win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: dual angle measurements  (Read 2835 times)

rico4life

  • Full Member
  • ***
  • Posts: 227
dual angle measurements
« on: November 25, 2013, 03:08:20 PM »
I just wondered what a rico drilled ball would be with mo pinels dual angle method?
Logged

 

Matt Fortney

  • Hero Member
  • *****
  • Posts: 2423
Re: dual angle measurements
« Reply #1 on: November 25, 2013, 03:52:38 PM »
Both angles would vary based on cg and/or mb placement, and both would depend on the bowlers axis point, but generally, it would result in relatively high drilling angle usually, and a very high VAL angle to put the pin that low compared to the fingers.
Logged

J_Mac

  • Hero Member
  • *****
  • Posts: 6778
Re: dual angle measurements
« Reply #2 on: November 25, 2013, 04:54:05 PM »
Quote from: rico4life on November 25, 2013, 03:08:20 PM
I just wondered what a rico drilled ball would be with mo pinels dual angle method?

Mo is not a fan of that drilling...

If you are looking for the type of ball reaction that everyone claims that the Rico layout is supposed to give, Mo suggests that you lay out a symmetrical ball with a dual angle layout of 15°x5"x50° and use a P4 gradient line balance hole.

He doesn't find a need to lay out asymmetrical equipment with such a scheme because the dual angle layouts need to be much more specific to the individual bowler on strong asymmetric equipment.
Logged

kidlost2000

  • Hero Member
  • *****
  • Posts: 5789
Re: dual angle measurements
« Reply #3 on: November 25, 2013, 05:50:51 PM »
Mo is also not a fan of anything not Mo. That is always obvious in his replies.
Logged
…… you can't  add a physics term to a bowling term and expect it to mean something.

kidlost2000

  • Hero Member
  • *****
  • Posts: 5789
Re: dual angle measurements
« Reply #4 on: November 25, 2013, 09:08:33 PM »
not sure that makes sense but go with it
Logged
…… you can't  add a physics term to a bowling term and expect it to mean something.

Xcessive_Evil

  • Hero Member
  • *****
  • Posts: 1853
Re: dual angle measurements
« Reply #5 on: December 03, 2013, 11:05:16 AM »
It would depend on your PAP.  Since rico is a general drilling and not an actual layout it will not only produce a different dual angle for each bowler, but it will roll different too.
Logged
Pages: [1]
« previous next »