BallReviews

General Category => Drilling & Layouts => Topic started by: Long Roller on October 06, 2006, 02:51:23 AM

Title: Finger hole depth
Post by: Long Roller on October 06, 2006, 02:51:23 AM

If you had 2.6 oz of top and 3 3/8" pin...How deep would you drill the fingers if the cg was 1" up and 1" right of the midline by rule?  61/64 drill bit.  I want the ball to be as strong as possible in the stacked position.  I really don't want to hear "buy a scale".   I'm just looking for a general answer.
--------------------
Shane Soule

Title: Re: Finger hole depth
Post by: Greg T on October 06, 2006, 10:57:54 AM

I don't see a need to drill any deeper than necessary to install grips. With 2.6 oz top weight you'll end up perfectly legal with standard drilling.
--------------------
Michael Jacksons schrie Lieblingsfudgeverpacker über meine letzte Unterzeichnung. So jetzt, muß sie zensiert werden!!
 

Title: Re: Finger hole depth
Post by: JohnP on October 06, 2006, 11:47:59 AM

Greg T is right if the cg is marked correctly and the top weight is correct.  But since you don't have a scale and don't want to get a pro shop to weigh it for you, I would suggest drilling the RF hole 1" extra deep.  That will take out enough side and finger weight to be sure it's legal unless the cg and/or top weight are grossly incorrect.  --  JohnP

Edited on 10/6/2006 4:31 PM

Title: Re: Finger hole depth
Post by: Long Roller on October 06, 2006, 01:33:11 PM

thanks guys

--------------------
Shane Soule