We all know that arsenal choices can vary and their is a vast difference of opinions, but I would like to see what you all think. For our discussion here let's state that the condition is medium and we are trying to set up a three ball arsenal for the wetter side of medium and drier side as well.
Item 1:
What is you benchmark layout. For me it is a medium range ball with approximate 3-5 inches of flare. Using a symmetrical ball the pin would be near ring finger height with no weight hole. If an asymmetrical ball it will be same pin height with M/B closer to 6.75 away from pap. Cover would be slightly polished ar about 2-4000 Abralon according to what ball i used.
Item 2:
Ball one won't recover so what is your next ball. For me it is a ball with lower pin placement (under ring finger) about 1.5 above midline with cg/mass bias right or near VAL with a weight hole. This ball should slow down and read the Brak Point better than ball one. Surface will be near ball one but probabaly a bit more aggresive than ball but that is per the ball choice.
Item 3:
Ball one hooks to much so what is your ball here. Some say use the arcy ball that revs later but i have found that a higher pin with about 3-5 inches flare above ring finger area with a strong recovery drill is best. For these reasons, u are usually left (right hander) and you need later / sharper recovery. The higher pin will get the ball longer and conserve energy for sharper recovery and carry from deeper.
So are their other thoughts? I would enjoy hearing your thoughts and the reasons as to why. I am always open to learn more....
Nod
--------------------
LTBOCSFM
