Author Topic: Full Roller layout (Read 858 times)

smitty8288 · « **on:** November 03, 2008, 06:52:51 AM »

I am having trouble with taming the backends on the dryer conditions. I have a jolt that I have polished and drilled straight up. I was told that putting a full roller layout to a ball would create negative weight and help give the reaction shape of something I desire. I was just wondering if this was true or is there a better layout that i should be considering.

Thanks in advance

the pooh · « **Reply #1 on:** November 03, 2008, 03:41:44 PM »

It probably would help,but you may roll over the thumb.IMHO a better solution would be to layout a ball with a 1 to 1 1/2" pin to pap.And go the other way on surface:No polish,2000 or 4000 abralon.The surface will cause the ball to start up sooner and backend less.The layout will help the ball to roll sooner,backend less,and flare less.

--------------------
the pooh

Author Topic: Full Roller layout (Read 858 times)

smitty8288

Full Roller layout

the pooh

Re: Full Roller layout