BallReviews

General Category => Drilling & Layouts => Topic started by: smitty8288 on November 03, 2008, 06:52:51 AM

Title: Full Roller layout
Post by: smitty8288 on November 03, 2008, 06:52:51 AM

I am having trouble with taming the backends on the dryer conditions. I have a jolt that I have polished and drilled straight up. I was told that putting a full roller layout to a ball would create negative weight and help give the reaction shape of something I desire. I was just wondering if this was true or is there a better layout that i should be considering.

Thanks in advance

Title: Re: Full Roller layout
Post by: the pooh on November 03, 2008, 03:41:44 PM

It probably would help,but you may roll over the thumb.IMHO a better solution  would be to layout a ball with a 1 to 1 1/2" pin to pap.And go the other way on surface:No polish,2000 or 4000 abralon.The surface will cause the ball to start up sooner and backend less.The layout will help the ball to roll sooner,backend less,and flare less.
--------------------
the pooh