win a ball from Bowling.com
« previous next »
Pages: 1 [2]

Author Topic: Need advice for a control drilling  (Read 4912 times)

Mr Bass

  • Hero Member
  • *****
  • Posts: 711
Need advice for a control drilling
« on: September 18, 2005, 09:28:57 AM »
Lately I've been struggling during my third games (during league) when the lanes break down. I'm planning on purchasing a Brunswick Rampage (pearl reactive) for this problem, although I haven't decided how to drill it. Would like to hear your thoughts. I am a high tracker, Stroker, medium ball speed and rev rate. I believe my PAP is about 4 1/2"...

--------------------
"Smokey this is not 'Nam this is bowling, there are rules"
"Maybe those Ebonite balls hit too hard. They're too good" -Jason Couch after leaving a stone 8 pin
"Yeah but the Brunswick ones get all ten though" -Brad Angelo
¡Viva la nación!
Logged

 

Mr Bass

  • Hero Member
  • *****
  • Posts: 711
Re: Need advice for a control drilling
« Reply #16 on: September 20, 2005, 02:39:25 PM »
quote:
Good to hear NextLevel.  Work on that axis tilt Mr. Bass.

Scott



Damn, I s*ck
--------------------
"Smokey this is not 'Nam this is bowling, there are rules"
"Maybe those Ebonite balls hit too hard. They're too good" -Jason Couch after leaving a stone 8 pin
"Yeah but the Brunswick ones get all ten though" -Brad Angelo
¡Viva la nación!
Logged

scotts33

  • Hero Member
  • *****
  • Posts: 8452
Re: Need advice for a control drilling
« Reply #17 on: September 20, 2005, 03:15:52 PM »
quote:
Damn, I s*ck  


I doubt you s*ck Mr Bass.  I bet you have a hard time when you move deeper inside?  A more versatile release would allow you better carry inside with more tilt.  

Scott
Logged
Scott

MelvinBrunsTrack

  • Hero Member
  • *****
  • Posts: 928
  • Don't blame the lanes, blame the bowler! Adjust!
Re: Need advice for a control drilling
« Reply #18 on: September 20, 2005, 03:24:58 PM »
I have a high track and my punisher is the ball I go to when the lanes are drying up.It's a control ball but it still hit very hard. My punisher is drilled pin next to ring finger i inch still in strong position. Very good ball
Logged

Ragnar

  • Hero Member
  • *****
  • Posts: 14084
Re: Need advice for a control drilling
« Reply #19 on: September 20, 2005, 03:26:42 PM »
A drilling that I've had some success with is a 1" pin with pin and CG each 1" from PAP.  Sort of a triangluar arrangement with pin stacked above CG.
--------------------
Got any good ideas, anyone?
Logged
Wyrd bið ful aræd!
(Thought to be a member of something called the PMS club by some.)
Pages: 1 [2]
« previous next »