BallReviews
General Category => Drilling & Layouts => Topic started by: dR3w on June 29, 2005, 11:25:26 AM
-
In your typical Hammer Drilling instructions, they list typically list High RG and Low RG drillings. What do High RG and Low RG refer to in these cases? I wouldn't think that they are refering to High RG and Low RG equipment, but rather positioning the ball for a cover heavy drilling, rather than a center heavy drilling. Can anyone explain this to me?
In viewing the drilling specs, it seems that the low RG drilling have pin to PAP distances less than 3 3/8, and high RG drillings have pin to PAP distances greater than 3 3/8. Is that the simple answer?
Edited on 6/29/2005 7:25 PM