BallReviews

General Category => Drilling & Layouts => Topic started by: REvans284 on December 13, 2007, 05:51:29 AM

Title: Has it been thought of or done? 3 piece exacticator switch grip.
Post by: REvans284 on December 13, 2007, 05:51:29 AM

Hey guys,

I was thinking last night, wouldnt it be nice to make a thumb mold in the form of a switch grip so you could make duplicates of your favorite thumb hole for the inner switch grip sleeve?  

I think it would be cool to have a set of inner and outer switch grip slugs that would allow for an 1 1/8 hole to be drilled in the inner slug and then an exacticator thumb slug inserted into that so you could have true duplicate inner slugs made for the switch grip system.  I may be going overboard with it a bit, because I'm sure you could fit a regular inner slug pretty close to another one, but it was just a thought I had and I've never heard of it being done before. Has this been done?

Later,

REvans284

Edited on 12/13/2007 2:52 PM

Title: Re: Has it been thought of or done? 3 piece exacticator switch grip.
Post by: TheDude on December 13, 2007, 02:48:54 PM

We did it once, friend put his copy thumb mold into a blank switch grip inner. it was a difficult fit but it worked.
--------------------
Timothy @Juniors Pro-Shops
LaSalle, Quebec
Located inside Pont Mercier Lanes.
Edmonton, Alberta.
Located inside Ed's Rec Room.(WEST ED MALL)

Roto-Grip Star Proshops
Storm VIP Shop
Etonic Stabilites Dress wearer.

Montreal, Quebec.

Title: Re: Has it been thought of or done? 3 piece exacticator switch grip.
Post by: Bigmike on December 14, 2007, 12:03:44 PM

You should be able to do it. Turbo sells the inners with slug or without.


--------------------
Mike Craig-Columbus, OH