Author Topic: Help needed with XY Jig (Read 1241 times)

johns811 · « **on:** April 30, 2005, 07:10:18 AM »

I picked up a used Rockwell with an XY jig. I userstand the pitch settings but am unclear on how to position the ball in jig.

Any help appreciated. Thanks

RSalas · « **Reply #1 on:** April 30, 2005, 03:16:20 PM »

Are you referring to the orientation of the ball within the jig? If so, I try to position the ball such that the centerline as marked on the ball is parallel to a line extending from the base of the press through the center of the jig.

Hope this helps.
--------------------
Better to be a big fish in a small pond than not to be a big fish at all.

Horrid in Doubles, torrid in Singles...
...that's The Curse of Dusty.

johns811 · « **Reply #2 on:** April 30, 2005, 03:19:47 PM »

Right, the orientation of the ball. That helps, thanks.

Author Topic: Help needed with XY Jig (Read 1241 times)

johns811

Help needed with XY Jig

RSalas

Re: Help needed with XY Jig

johns811

Re: Help needed with XY Jig