Post by: snakes on June 11, 2003, 08:47:55 AM
He asked me about suggesting some patterns for him.
He throws the ball about 13-14 MPH as well. Not many revs at all.
What would you guys suggest for pin and CG placements for a 4 ball layout?
I told him to keep the pin above a line from the ring finger to the PAP.
He has 5 balls drilled 4x5, 4x6.
I think he needs some variety.
Thanks,
Snakes
Post by: Jeffrevs on June 12, 2003, 07:31:22 AM
Moreso ..... on a line from pap to pin that finishes above the ring finger hole.
Yes,......whatever is favorite drill is,.....have 2 balls with that, (label), then have one stacked, 4x4, then have a arcing drill, or earlier roll drill, say 4x2. Start off with 3 inch pins at least. He could also get a 3-4 inch pin out ball and do a 2.5x5 as long as the pin and pap make a line that goes above the ring finger......
Ragnar has done experiments with these type drillings (he's a high tracker too) and he may chime in as well
...O.O
............p
...............pap
....CG
....O
--------------------
JEFF