BallReviews

General Category => Drilling & Layouts => Topic started by: hamma on January 02, 2010, 01:43:36 PM

Title: how do i interpret the oem layout sheet
Post by: hamma on January 02, 2010, 01:43:36 PM

i am looking at the bw nasty layout sheet for skid/flip (#1).  when given two coordinates, i can usually layout my ball, but i am not recognizing a second coordinate here,  is there an understood that i am missing? just trying to learn and figure out which layouts work best for me.
--------------------
currently using storm natural and ogre urethane.  about to purchase bw nasty, jigsaw corner and bounty hunter pearl.

Title: Re: how do i interpret the oem layout sheet
Post by: Bluff on January 03, 2010, 12:26:43 AM

view-source:http://www.bowlingball.com/info/hammer-drilling-layout-index.html#Layout
--------------------
"A man with no skills can be taught. A man with no honor, has nothing."

Title: Re: how do i interpret the oem layout sheet
Post by: hamma on January 03, 2010, 07:07:15 AM

thanks bluff, i will bookmark that site, but i didn't see what i think i need, which is a pap to mb measurement or a pin buffer.

Title: Re: how do i interpret the oem layout sheet
Post by: JohnP on January 03, 2010, 03:51:45 PM

The drill sheet says to put the MB in the strong position.  Genrally, this is 3 - 4" from the PAP.  --  JohnP

Title: Re: how do i interpret the oem layout sheet
Post by: hamma on January 03, 2010, 05:39:29 PM

thanks johnp, i do as much reading as i can but i evidently missed that one.  thanks again...
--------------------
currently using storm natural and ogre urethane.  about to purchase bw nasty, jigsaw corner and bounty hunter pearl.