win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Pin rising out - Help!!  (Read 1171 times)

Leftyhi-trak

  • Hero Member
  • *****
  • Posts: 2288
Pin rising out - Help!!
« on: September 30, 2008, 01:41:18 PM »
I have two Ebonites that have been sitting a year when i opened the bag I noticed both had the pin raised up between 3/4 and 1 1/4 inches. I touched one and  it felt slightly mushy like clay. What is best option for fixing this issue?
Logged

 

Juggernaut

  • Hero Member
  • *****
  • Posts: 6498
  • Former good bowler, now 3 games a week house hack.
Re: Pin rising out - Help!!
« Reply #1 on: September 30, 2008, 09:46:08 PM »
Mine weren't sticking out THAT far, but I just took them to the shop where they used the spinner and a bevel knife to trim/shave the pins back down, then cleaned up the surface of the ball.

  I had a pin come completely out of a ball once.  The shop just mixed up a bit of colored plug and poured it into the hole, just like plugging any other hole, and it worked out fine.
--------------------
"The difference between stupidity and genius is that genius has its limits."
Albert Einstein

Good transactions list in my profile



My Bowl.com member page

Logged
Learn to laugh, and love, and smile, cause we’re only here for a little while.

themagician

  • Hero Member
  • *****
  • Posts: 2974
Re: Pin rising out - Help!!
« Reply #2 on: September 30, 2008, 10:18:07 PM »
Wow, i've never heard of them like that, i've heard of a pin falling out before but not having it mushy.

I'd suggest cutting it off or drilling it out. I've seen shops drill out pins and replug the area and go on like nothing happened.
--------------------

http://www.absolutebowling.com
Logged
-Mike
-MOTIV Staff

Greg T

  • Hero Member
  • *****
  • Posts: 19916
  • Collateral Damage
Re: Pin rising out - Help!!
« Reply #3 on: September 30, 2008, 10:21:24 PM »

 Must have been in cold storage. Nipples are hard. But seriously, folks......Cut'em off.




Logged
AllBowling.com Off-Ramp!           

JohnP

  • Hero Member
  • *****
  • Posts: 5819
Re: Pin rising out - Help!!
« Reply #4 on: October 01, 2008, 10:22:54 AM »
I would drill them out and plug the hole.  --  JohnP
Logged

BowlerKidR

  • Hero Member
  • *****
  • Posts: 2024
Re: Pin rising out - Help!!
« Reply #5 on: October 01, 2008, 10:25:37 AM »
This was a very common occurrence on the Ebonite/Hammer balls from a few years back, specifically the Viscous line from Hammer and the Apex line from Ebonite. As for the solution, either cut the pin down with a plug cutter/router and clean up the cover or just hack away at it with a bevel knife. Very simple fix.
--------------------
"Strike for show, spare for dough"
Im A Hammer Head 100%
http://ryman624.googlepages.com
Logged
Pages: [1]
« previous next »