BallReviews
General Category => Drilling & Layouts => Topic started by: Iketown300 on November 15, 2004, 03:26:08 AM
-
Hey all, I am looking to fit my Dirty Bomb inbetween my x factor ace and my uranium. The ace is drilled 4 1/2 by 2 with a 3/4" x hole on my pap. The uranium is drilled label leverage 3 3/8 by 5 with a small weighthole on my pap. My PAP is 4 5/8 right and 1/2 down. I throw with medium speed and the lower end of medium revs. My Ace seems to pick up too early sometimes on the THS so i use it for the medium/heavy shots i see in tourneys. The uranium seems to not come in enough at the back and leave 10's for the first game and a half but then i can get it to turn the corner and start carrying after that. Let me know your thoughts. It will be here tuesday! Thanks in advance!
--------------------
Ike Brownfield
-
Pearl Resin with a big ole flip block,..I'm a believer in drilling a ball the way it was built to perform,..what ever your favorite long and strong/flip drill is what I'd use. jim
--------------------
www.dynothane.com
-
So you are saying pin over bridge and cg out about 1" maybe 1 1/2?
--------------------
Ike Brownfield
-
if that's a proven layout for you then that's what I would do,..to me this ball is built to go long,..store energy,..and pop around the corner on the back. Sure there's different ways that you can drill any ball,..but why try and defeat the purpose of it's design,..but that's just my way of thinking.
--------------------
www.dynothane.com
-
Right I agree but I do have a question though...what are some other go long and flip hard drillings?
--------------------
Ike Brownfield
-
Ike, I would go with a 4 1/4 x 4 1/4, pin over the fingers. This will start up sooner than the Uranium and not burn up as quick as your Ace. =:^D