BallReviews
General Category => Drilling & Layouts => Topic started by: And1_headach on July 26, 2006, 07:48:43 AM
-
In 3 of my old balls i had the removable thumb insert placed in my ball. i want to remove the outer sleave. the gentleman who originally put the insert in closed his shop down. i now need a bit one size bigger than a 1 3/8. if you have anything please messsege me!
--------------------
MESSING AROUND IN PRACTICE, IS ONLY PRACTICING BAD HABITS!
-
Not thatit's much help, but the 1-1/2 is more needed for installing. I had the same problem, but the shop was able to remove the sleeve with a 1-3/8 with a little wiggling. No help for install, but it does work for removal....
--------------------
Signature? I don't need no stinking signature...
-
yeah, i think ill try that this afternoon
--------------------
MESSING AROUND IN PRACTICE, IS ONLY PRACTICING BAD HABITS!
-
Do you use thumb slugs at all? I have a Vapor Zone with the Turbo Switch Grip sleeve in it and I decided to not use a ton of plug and just glued in a 1 3/8 inch slug in the sleeve and drill the new pitch in the slug. Worked out fine for me. I took the sander to the sleeve a bit to help the glue and then knocked down the excess slug with the router.
-
i ended up using the 1 3/8 bit, going to the bottom and breaking it out. then wiggling the bit and slowly notching off the sides. i was able to get the rest out with a pair of pliars*SPELLING*.
--------------------
MESSING AROUND IN PRACTICE, IS ONLY PRACTICING BAD HABITS!