BallReviews
General Category => Drilling & Layouts => Topic started by: Next Level PS on April 29, 2004, 01:16:39 PM
-
what is the reason for this? a guy brought this into the shop today.
O O pin
cg
+
O X-hole
I thought the the Cg was a locater for position the X-hole on the VAL. the hole was 1.5" deep it did not change the shape of the core design. it just added excess finger weight. have any other driller done this out their?
--------------------
www.bowlritelanes.com
www.nextlevelproshop.com
also know as VortexII