I have just been given a superpower and the Pin is only 1 inch away from the cg. Apparently this is going to make it roll early what drilling can I get to give it a bit more length and backend?

Well Mainly I want a fair bit of length but a decent backend, I already have a sp with a pin 4 inches from the cg but its not highly polished and it burns up before it hits leaving me loads of single pins.

I'm more Walter ray than Robert smith ( More down and in than out and in ) Tweener.....

Seeing as you are more of a straighter player,
I might would suggest putting a 315 on the ball.

What is the top wt?  YOu need a 1" pin and 2.5oz tw to do the
315.

I put a 315 on a charcoal executioner, and polised it to 1000.
It gets through the heads and still has a good finish on it.
--------------------
Eric T. Spivey, P.E.
 Visionary Test Staff Member
http://www.visionarybowling.com

Jabroni, for what it's worth, I used a Roto Grip Major Assault with a 315 layout a couple of weeks back on pretty dry conditions.  In a house where I normally have played right of 1st arrow I was playing left of 15.  Now the MA was highly polished, but it is a pretty aggressive ball.  I had not trouble with it on the dry.  Yes, it was pretty early, but really sort of glided thru the front and had a minimal reaction off the back.  But I don't think this layout will help Supernoodle; it may get him more length, but it won't add any backend, imo.
--------------------
Just run to the line, plant and heave.