Post by: gtkpr31 on December 01, 2008, 02:45:55 AM
425 rpm
pap 3 1/2 right -- 0 up and down
ball speed 18-19 mph
With my low track I'm starting to think it will be almost impossible to get a ball drilled the proper way. I have a total nv drilled pin in palm that gives me the highest ball track but it is FAR from rolling out. All of my balls backend like mad because of my rev rate and low track and I'm looking for something that will roll out so I have a lot more control.
Low pins give me more control but are still not what i'm looking for. If anyone has any ideas, your input is greatly appreciated. Thanks.
--------------------
This is life.
This is struggle.
This is love.
This is war.
Post by: LFSoccer2k6 on December 01, 2008, 11:02:24 AM
--------------------
Greg Townsend
Best Bowling Pro Shop, Inc.
Lindenwood University Bowling
Post by: gtkpr31 on December 01, 2008, 11:06:00 AM
lfsoccer, I have a Thunderstruck Pearl that has the pin about 2" from the pap, and it rolls pretty early and smooth even though it's a pearl...but the fact that's it's a pearl and is shiny might prevent the roll out...I might put a low low grit on it and see what I come up with.
--------------------
This is life.
This is struggle.
This is love.
This is war.
Post by: leftyinsnellville on December 01, 2008, 11:13:05 AM
http://marketing.lanemasters.com/LM_Ball%20Drilling%20Instructions.pdf
Look at the "Pin Axis" layout.
--------------------
220...221...whatever it takes.
Post by: gtkpr31 on December 01, 2008, 11:57:55 AM
--------------------
This is life.
This is struggle.
This is love.
This is war.
Post by: LFSoccer2k6 on December 01, 2008, 12:08:08 PM
take the pin and CG and flip them. put the pin under bridge or middle finger and put the CG above the fingers. this will cause the ball to be very smooth, no backend, and basically roll out.
--------------------
Greg Townsend
Best Bowling Pro Shop, Inc.
Lindenwood University Bowling
Post by: Gazoo on December 05, 2008, 07:54:53 AM
--------------------
"I don't want to be remembered, I want to be forgotten"
Post by: strikealot on December 07, 2008, 05:41:48 PM
--------------------
~<:-0======"IN CG WE TRUST" i chant as i pray to the static weight God...======
Post by: gtkpr31 on December 09, 2008, 01:42:14 PM
4 x 3 ½†with a 3†Pin Buffer. This will put the Pin directly under my middle finger, just left of my midline. The high flare potential will force the ball into a roll, but the location of the Mass Bias will cause the ball to lose axis tilt as soon as possible. The 1000 grit finish will also generate a fair amount of friction forcing the ball into a roll sooner.
I'm going to try this layout and see what happens. But he told me with my tilt and pap and my rev rate it might not totally roll out...so i guess i'm hopeless
--------------------
This is life.
This is struggle.
This is love.
This is war.
Post by: LeftyGomez on December 10, 2008, 12:01:01 PM