Author Topic: Layout on a Brunswick Swarm (Read 955 times)

leftyinsnellville · « **on:** April 17, 2009, 04:45:32 AM »

I picked up a used Brunswick Swarm.

The span is perfect, but I went ahead and filled the holes anyway. I am wondering what kind of reaction I could expect if I went ahead and used the same layout (thus keeping the ball as a single drill).

The layout with my specs is:

- 3 inches pin to pap

- 4 1/2 inches cg to pap

- cg is only 1/8 of an inch from being directly in the middle of the centerline

- pin is located left of ring about one inch

- pin is 1/2 inch higher than the center of the ring

The drill sheet doesn't really show any layout like this, but I would presume I could expect a little more length than average and a fairly weak overall reaction.

Any input would be greatly appreciated.

Thanks!

Edited on 4/17/2009 12:46 PM

Gazoo · « **Reply #1 on:** April 17, 2009, 01:05:50 PM »

Sounds like a basic 1:30 label leverage drill. Will give you moderate length with a controlled arcing backend. Not weak, but not skid/snap.
--------------------
"I don't want to be remembered, I want to be forgotten"

Author Topic: Layout on a Brunswick Swarm (Read 955 times)

leftyinsnellville

Layout on a Brunswick Swarm

Gazoo

Re: Layout on a Brunswick Swarm