Forget about named layouts    Just learn what dual angles you like and go from there... but literally anything "leverage" the pin is 3 3/8" from PaP.. so axis lvg the pin is 3 3/8" from PaP and the cg was put on PaP with it drilled out.. Rev lvg the cg is 3 3/8" from PaP but in the thumb/positive quadrant w/ a hole 6 3/4" on a line from pin through cg ..

I used to use dual angle, had a alpha crux drilled today, we looked at other ball I like a lot which was a axis leverage drilling. We did figure out that a 20x20x3 dual angle drilling works best for me. Don't really know why this works so well for me it just does, hooks as much as I wanted and never quits. my pap is 4 1/2 and 3/4 up.

Are you strongly speed dominant with a lot of axis tilt and rotation?  --  JohnP