Author Topic: leverage??? (Read 1328 times)

bowlingforfun · « **on:** October 13, 2003, 04:36:47 AM »

In drilling I always see the term leverage. Can someone please explain this to me. As in what this drilling would look like an what type of reaction. Thank you.

Strider · « **Reply #1 on:** October 14, 2003, 01:19:43 PM »

Leverage is when the pin is at 3 3/8" from the Positive Axis Point. That's the maximum flare/hook (in general) that you'll get out of a ball.

Label leverage = pin at 3 3/8" from PAP, CG in center of grip.

Max leverage = pin and CG at 3 3/8" from the PAP (pin usually 1-2" from the ring finger, CG more or less stacked underneath, just below midline)

Axis leverage = pin at 3 3/8" from PAP, CG on PAP

Rev leverage = pin at 3 3/8" from PAP (closer to midline) and CG to the right of the thumb.

Ebonite has some good pictures and descriptions.

http://www.ebonite.com/ Go to "Tech Center", then pick a symmetrical ball like the V2 sanded.
--------------------
Penn State Proud

Author Topic: leverage??? (Read 1328 times)

bowlingforfun

leverage???

Strider

Re: leverage???