BallReviews

General Category => Drilling & Layouts => Topic started by: REVOLUTIONS PS on October 26, 2009, 09:48:28 AM

Title: LevRG Tracking over fingers
Post by: REVOLUTIONS PS on October 26, 2009, 09:48:28 AM

I've been out of the pro shop end of the business for a couple years now as I've moved into centre management but I still know my way around the drill press.  However, I drilled a customer of mine a Morich LevRG with a label-type drilling, pin next to the ring finger (which is about 5 1/2" from his axis) and the MB was in his track.  The ball rolled over the middle finger and I was wondering if anyone else has had this problem with this particular ball.

Title: Re: LevRG Tracking over fingers
Post by: walterrayseggs on October 26, 2009, 10:30:53 PM

If the pin was placed there, and it is in fact 5 1/2 from his PAP, that means his PAP is like 6 1/2> or better. The ball starts on the fingers.

Title: Re: LevRG Tracking over fingers
Post by: charlest on October 27, 2009, 06:58:07 AM

Any chance of putting in one of those weight holes that raise the bowtie?
(Thumb positive quadrant, about 2.5" - 3" below his PAP on the VAL, removes side and thumb weight)

--------------------
"None are so blind as those who will not see."