BallReviews

General Category => Drilling & Layouts => Topic started by: Thunder835 on October 09, 2009, 09:39:40 AM

Title: Looking for Bits
Post by: Thunder835 on October 09, 2009, 09:39:40 AM

I am looking for a set a straight shank drill bits.  I am trying to find a decent used set.  If anyone has any, please message me with prices.  Thanks!
--------------------
Track PBA Regional Staff

http://s318.photobucket.com/albums/mm427/thunder835/Track%20Equipment/

Evolutionary. Revolutionary.
People don''t lack strength, they lack will.

Title: Re: Looking for Bits
Post by: Moon57 on October 10, 2009, 07:00:12 AM

Check out EBay. Sometimes you can get good deals on bits.
--------------------
Moon
--------------------
So many questions, so little time but I'm having fun.

Title: Re: Looking for Bits
Post by: tommymo on October 10, 2009, 07:28:43 AM

Innovative has a set in their bargin bin.
--------------------
Your mind is like a parachute . . . Useless if it's not open!!!!

10/21/05 Kaitlyn Emily and  02/01/07 Meghan Alexis, Daddy's little girls! 06/02/09 Zachary Thomas, Finally daddy's little man!!!

R.I.P Kevin Trombley 11/26/05 You were taken too soon!

Visionary Test Staff Member 07-Current
Frankie May Gryphon
Immortal Pearl
Ogre Pearl
Ogre SS
Gladiator
B/G Centaur

Title: Re: Looking for Bits
Post by: JohnP on October 10, 2009, 08:10:09 PM

I have an extra set of #2 Morse taper bits.  You can get an adapter for #2 MT to straight shank at Innovative, I don''t know how much more quill travel it would require.  I also have a #2 MT plug cutter that I can''t use.  I''ll take $150 + actual shipping cost for all of them.  If you''re interested send me a PM and I''ll give you more information on the bit sizes and answer any questions.  --  JohnP

Edited on 10/10/2009 8:11 PM

Title: Re: Looking for Bits
Post by: Pinhammer on October 12, 2009, 10:31:43 AM

Basic set or full set?
--------------------
Roger Carroll
Pinnacle Pro Shop
Clarksville, TN

Title: Re: Looking for Bits
Post by: JohnP on October 13, 2009, 10:03:52 AM

Pinhammer -- I don't know if your question was for me or not, but if it was -the set, best as I remember without checking my list at the shop, is 5/8" - 1 1/8" in 1/16" increments, no 64th" bits.  All are carbide tipped, some are AMF but most don't have a manufacturer's name on them.  --  JohnP

Title: Re: Looking for Bits
Post by: sunsetlefty on October 13, 2009, 08:59:10 PM

I have a 40 piece straight shank set, purchased from Ultimate Bowling Products, that is basically brand new. 2 of the bits were used to drill 1 ball. That''''s it.

If you are interested, PM me.

--------------------
Gary Palma
Owner of X-act Reaction pro shop at Ideal Lanes
www.myideallanes.com
Rotogrip Star Pro Shop Member
Ebonite International Gold Pro Shop Member
PBA Member


Edited on 10/13/2009 9:00 PM

Edited on 10/13/2009 9:09 PM