BallReviews

General Category => Drilling & Layouts => Topic started by: Greg T on February 08, 2008, 04:01:34 PM

Title: Looking for layout advice
Post by: Greg T on February 08, 2008, 04:01:34 PM

 I have an older gent who purchased a BWP. This guy is medium spedd, but very low rev. his ball may make about 6 to 8 revolutions down the lane. We have a decent amount of oil with little backend. I had in mind something that will give him an early but smooth arc. Lower pin about 4x3 or so. Opinions?



--------------------
If yer arm don't hurt ya ain't shiftin it right!
 
RESEARCH!   Don't be a maroon!!.
 (http://"http://webpages.charter.net/gat/Web%20Posts/Bugs13.wav")

 

Title: Re: Looking for layout advice
Post by: Brickguy221 on February 09, 2008, 10:40:27 AM

I'm low rev, but not that low. The majority of my balls have the Pin under RF, under Bridge, etc. and in that area with the CG out or a ball with a MB, the MB 4" to 5" from my PAP depending on the strength of the Ball and MB and whether I want a weight hole or not. The Pin in the under fingers in some capacity helps low rev people to get the ball reving earlier.
--------------------
"Whenever I feel the urge to exercise I lie down until the feeling passes away."

Brick

Title: Re: Looking for layout advice
Post by: novawagonmaster on February 09, 2008, 11:49:03 AM

Any reason a Rico drill would not work?
--------------------
Jon (in Ohio)

Title: Re: Looking for layout advice
Post by: Greg T on February 09, 2008, 12:48:58 PM

  I'll have to wait til I check his pap before deciding what to do, but pin down sounds like it should be good. Rico, very good possibility, but i have seen a good number of bowlers roll over the fingers with this if they track high.


--------------------
If yer arm don't hurt ya ain't shiftin it right!
 
RESEARCH!   Don't be a maroon!!.
 (http://"http://webpages.charter.net/gat/Web%20Posts/Bugs13.wav")