BallReviews

General Category => Drilling & Layouts => Topic started by: rotofreak on March 22, 2008, 04:18:11 PM

Title: mb question?
Post by: rotofreak on March 22, 2008, 04:18:11 PM

How much effect if any when the MB is outside the VAL. And what will the characteristics be?

Thanks.

ROTO

Title: Re: mb question?
Post by: NicholasE on March 23, 2008, 12:33:39 AM

For me it depends where the pin is. If the pin is up and MB near the Val, its very controllable with a arching reaction. With pin down and MB near the VAL, it gives me length and a hard arch on the backend, usually pretty strong. Thats just my experiences with it, but could vary for different people and ball characteristics.
--------------------
Throwing hambones since 2005.
www.myspace.com/nestes12

Title: Re: mb question?
Post by: rotofreak on March 23, 2008, 12:37:36 AM

The pin is going to be down, but I want to know is it going to hurt anything to put the MB 1" past VAL?

Title: Re: mb question?
Post by: charlest on March 23, 2008, 08:29:23 AM

Don't forget that the effect of that positioning will be magnified by the strength of the mass bias rating. That is, for the high rated LevRG (.033") the effect will be much greater than for a Black Widow with a much lower Mas bias rating (.014").
--------------------
"None are so blind as those who will not see."
Unofficial Ballreviews.com FAQ (http://"http://home.mchsi.com/~s-cross-7-28-71/FAQ.htm")

Title: Re: mb question?
Post by: rotofreak on March 23, 2008, 09:23:00 AM

I have this laid out in a Cell, not drilled just laid out. Anything to worry about?

Title: Re: mb question?
Post by: EdKramarcak on March 23, 2008, 11:11:32 AM

YES