BallReviews

General Category => Drilling & Layouts => Topic started by: Doug Sterner on September 06, 2004, 03:07:51 PM

Title: Measuring for a Pinky Hole
Post by: Doug Sterner on September 06, 2004, 03:07:51 PM

I was just aproached for the first time since I have been drilling to put a pinky hole in a ball for a customer.

What is the proper way to measure for such a grip? Do I measure for teh middle and ring, take the specs and then redo the fitting ball and have her use her ring and pinky instead?

Help me out here guys. Thanks.
--------------------
Doug Sterner
Doug's Pro Shop
Owego, NY
http://dougsproshop@aol.com
www.dougsproshop.net
The Cherry is the Bomb
And the Uranium blows them all away!
Now accepting VISA/MC and Discover for your purchases

Title: Re: Measuring for a Pinky Hole
Post by: TheBowlingKid25 on September 06, 2004, 11:10:24 PM

I would say to measure there ring and middle first, then just lay there ring finger over the middle finger hole, and have them put there pinky in the ring finger hole.
--------------------
16 years and still going strong! 16 years old that is! The names Warrior Princess, Xena..Warrior Princess
And why would I "saw" pins in half, THATS A WASTE OF PINS!

Title: Re: Measuring for a Pinky Hole
Post by: Next Level PS on September 06, 2004, 11:21:45 PM

Doug, I have a few of these players, if you have a jayhawk measuring ball just mearure as if it was the RF or MF. just make the Bridge from the ring hole to the Pinky hole a 1/2" wide. also the lateral Pitches on the Ring may have to be adjuster so that you do not "V" the two holes.
--------------------
www.bowlritelanes.com
www.nextlevelproshop.com