Author Topic: Need question answered about switch grip outer sleeve (Read 2167 times)

jkiser01 · « **on:** April 18, 2010, 04:29:13 AM »

I bought a used ball on here and it had the switch grip outer sleeve installed. I was going to just get a new inner sleeve done but just noticed the span is shorter (about an 1/8th) than I like. My question is this. Can I drill out that outer sleeve with a 1 3/8 slug and drill right back into that to make the span a bit longer or am I going to have to plug the thumb and start over..

I just need to know the inside dimensions of the switch grip outer sleeve..

Thanks in advance..
--------------------
My first child.. Hannah Allison Kiser born 4/30/2007... My little angel..

Roto Grip.. King of Them All!!

Storm ain''t so bad either!! LOL

I also like AMF/900 Global..

Japaters · « **Reply #1 on:** April 18, 2010, 01:23:12 PM »

The inside diameter is about 1 3/8, but you will be better off to drill out the outer sleeve and plug, then redrill. I have tried both and the plugging method yields better results.

Flip-Side-Wow · « **Reply #2 on:** April 19, 2010, 02:26:48 PM »

http://www.turbogrips.com/products_switch_grip.php

They are now making a 1 3/8 solid inner sleeve, which may allow you to change the span without plugging. Guess it will depend on your thumb diameter as to whether you'll get the 1/8" span change though.

coop1760 · « **Reply #3 on:** April 19, 2010, 07:01:24 PM »

what about drilling the inner back an 1/8. it was done for a friend so he could share balls with his doubles partner at nationals.

Author Topic: Need question answered about switch grip outer sleeve (Read 2167 times)

jkiser01

Need question answered about switch grip outer sleeve

Japaters

Re: Need question answered about switch grip outer sleeve

Flip-Side-Wow

Re: Need question answered about switch grip outer sleeve

coop1760

Re: Need question answered about switch grip outer sleeve