BallReviews

General Category => Drilling & Layouts => Topic started by: TravisG on February 18, 2007, 02:14:13 AM

Title: Need some advice.
Post by: TravisG on February 18, 2007, 02:14:13 AM

Ok I am getting a Roto Grip Neptune and need some suggestions on how to get lots of lenght and a smooth arc to the pocket. I am a high tracker, high rev bowler and most balls i have been throwing like my Low Flare Stinger pearl drilled pin above ring cg kicked out, have been too strong off the break. So guys give me some good drillings that will work. Thanks in advance.

Title: Re: Need some advice.
Post by: Aloarjr810 on February 18, 2007, 10:41:47 AM

My friend is doing good with his Rotogrip using-

Drilling A -
6" pin from PAP with the mass bias in the track (position A).

Drill sheet link
http://www.rotogrip.com/pdf/reactiondrillchart.pdf

Title: Re: Need some advice.
Post by: TWOHAND834 on February 18, 2007, 10:50:48 AM

I would try putting the pin 2-3 inches from PAP and the cg near the center of grip.  This layout allows for a much smoother transition down the lane and tames the breakpoint.  With your track and rev rate, you will still get decent overall hook; just a smoother breakpoint.
--------------------
Steven Vance
Former Pro Shop Operator

If anyone out there is worried about the scores being too high, try duckpin!!