win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: new drilling layout  (Read 1338 times)

FCbowler12

  • Full Member
  • ***
  • Posts: 138
new drilling layout
« on: November 17, 2006, 06:41:15 AM »
Ok i am about to order a new Power Machine here in the next few days and was looking for a new drilling layout. im not very particular about drilling and never have been. i was looking for a layout that would make the ball specifically for going deep and cutting in hard at the end. any suggestions would be appreciated
--------------------
http://www.strikeandsparebowling.com
http://www.amf.com/derbylanes
http://www.ferncreekhsbowling.bravehost.com
Logged

 

Bowler19

  • Sr. Member
  • ****
  • Posts: 433
Re: new drilling layout
« Reply #1 on: November 17, 2006, 07:46:52 PM »
Mass bias needs to be in the strong position. get the pin up keeping the MB Approx. Even with the thumb. The pin should be between 3 3/8 and 4 in from PAP

depending on you rev rate you will want to choose a pin position.

high revs go with about a 4 in pin lower revs go with 3 3/8


I use pin 4.5 from axis and MB on the strong position for longer med/heavy oil for deep.

For a little straighter angle on that type of pattern 5.5in pin from axis and MB just to the NEG side of thumb.
--------------------
Bowler19
But be not afraid of greatness: some are born great, some achieve greatness, and some have greatness thrust upon them.-W. Shakespear
Logged

cmoore3wins

  • Hero Member
  • *****
  • Posts: 708
Re: new drilling layout
« Reply #2 on: November 18, 2006, 11:41:28 PM »
Brandon,

One would need to know your ball speed, rev rate, tilt, rotation and the environment you bowl in to best match you to a layout.
--------------------
MoRich makes me mo rich, cuz I sell the 300 & 800 rings on eBay....
While you're leaving corners, I am laughing inwardly....
My core has a hole in it, but your score sheet does....
I flip out ten pins, you flip them off....
Mos cores = Mo scores....


Edited on 11/19/2006 0:32 AM
Logged

FCbowler12

  • Full Member
  • ***
  • Posts: 138
Re: new drilling layout
« Reply #3 on: November 19, 2006, 11:06:10 AM »
16-17mph ball speed med revs ( 300 ) and light-med lan conditions
--------------------
http://www.strikeandsparebowling.com
http://www.amf.com/derbylanes
http://www.ferncreekhsbowling.bravehost.com
Logged
Pages: [1]
« previous next »