BallReviews

General Category => Drilling & Layouts => Topic started by: FCbowler12 on November 17, 2006, 06:41:15 AM

Title: new drilling layout
Post by: FCbowler12 on November 17, 2006, 06:41:15 AM

Ok i am about to order a new Power Machine here in the next few days and was looking for a new drilling layout. im not very particular about drilling and never have been. i was looking for a layout that would make the ball specifically for going deep and cutting in hard at the end. any suggestions would be appreciated
--------------------
http://www.strikeandsparebowling.com
http://www.amf.com/derbylanes
http://www.ferncreekhsbowling.bravehost.com

Title: Re: new drilling layout
Post by: Bowler19 on November 17, 2006, 07:46:52 PM

Mass bias needs to be in the strong position. get the pin up keeping the MB Approx. Even with the thumb. The pin should be between 3 3/8 and 4 in from PAP

depending on you rev rate you will want to choose a pin position.

high revs go with about a 4 in pin lower revs go with 3 3/8


I use pin 4.5 from axis and MB on the strong position for longer med/heavy oil for deep.

For a little straighter angle on that type of pattern 5.5in pin from axis and MB just to the NEG side of thumb.
--------------------
Bowler19
But be not afraid of greatness: some are born great, some achieve greatness, and some have greatness thrust upon them.-W. Shakespear

Title: Re: new drilling layout
Post by: cmoore3wins on November 18, 2006, 11:41:28 PM

Brandon,

One would need to know your ball speed, rev rate, tilt, rotation and the environment you bowl in to best match you to a layout.
--------------------
MoRich makes me mo rich, cuz I sell the 300 & 800 rings on eBay....
While you're leaving corners, I am laughing inwardly....
My core has a hole in it, but your score sheet does....
I flip out ten pins, you flip them off....
Mos cores = Mo scores....


Edited on 11/19/2006 0:32 AM

Title: Re: new drilling layout
Post by: FCbowler12 on November 19, 2006, 11:06:10 AM

16-17mph ball speed med revs ( 300 ) and light-med lan conditions
--------------------
http://www.strikeandsparebowling.com
http://www.amf.com/derbylanes
http://www.ferncreekhsbowling.bravehost.com