win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Pin in drillings  (Read 1164 times)

Gonz

  • Full Member
  • ***
  • Posts: 169
Pin in drillings
« on: June 06, 2008, 12:35:34 PM »
Hi Gang,

I purchase a symmetrical urethane ball for mom. She is a senior with slower speed,low revs and tracks very close to the thumb. Ball that I received was pin in 1.5 to 2.0"

I am looking for some suggestions on drilling this up. She bowls on a THS and naturally struggles with her reactive as the lane breaks down. I know this question regarding pin in drilling has probably been asked a million times, but I am looking and hoping for some knowledgeable readers to offer some advice.

Thanks for your help!
Gonz
Logged

 

T-GOD

  • Hero Member
  • *****
  • Posts: 2141
Re: Pin in drillings
« Reply #1 on: June 07, 2008, 12:09:10 AM »
I would go with something close to a label leverage drilling with 1/2 side 1/2 finger. This should get the ball down the lane with some pop at the end. Good luck. =:^D
Logged

Gonz

  • Full Member
  • ***
  • Posts: 169
Re: Pin in drillings
« Reply #2 on: June 07, 2008, 12:13:35 AM »
Thanks T-God!!

Gonz
Logged
Pages: [1]
« previous next »