BallReviews

General Category => Drilling & Layouts => Topic started by: Gonz on June 06, 2008, 12:35:34 PM

Title: Pin in drillings
Post by: Gonz on June 06, 2008, 12:35:34 PM

Hi Gang,

I purchase a symmetrical urethane ball for mom. She is a senior with slower speed,low revs and tracks very close to the thumb. Ball that I received was pin in 1.5 to 2.0"

I am looking for some suggestions on drilling this up. She bowls on a THS and naturally struggles with her reactive as the lane breaks down. I know this question regarding pin in drilling has probably been asked a million times, but I am looking and hoping for some knowledgeable readers to offer some advice.

Thanks for your help!
Gonz

Title: Re: Pin in drillings
Post by: T-GOD on June 07, 2008, 12:09:10 AM

I would go with something close to a label leverage drilling with 1/2 side 1/2 finger. This should get the ball down the lane with some pop at the end. Good luck. =:^D

Title: Re: Pin in drillings
Post by: Gonz on June 07, 2008, 12:13:35 AM

Thanks T-God!!

Gonz