BallReviews

General Category => Drilling & Layouts => Topic started by: Krumpy300 on February 15, 2006, 10:56:25 PM

Title: Pin under middle finger
Post by: Krumpy300 on February 15, 2006, 10:56:25 PM

I've always leaned towards pin over drillings ( I don't bowl on a lot of oil)but I have seen a lot of pin under middle finger drillings popping up in my area. My current favorite is pin over and between the fingers with the CG kicked towards the PAP a bit. (5x4)

What will pin under the middle finger do compared to pin above and between?

Thanks.

Title: Re: Pin under middle finger
Post by: NappyCuts on February 16, 2006, 06:58:49 AM

Cause slightly earlier roll, and a little bit less jump on the backend.

Title: Re: Pin under middle finger
Post by: agroves on February 16, 2006, 07:27:30 AM

If you track high, you better be careful.  You could clip the finger holes.  I can drill pins low with no problems, my pap is 5 1/2 over.  Most would consider that too high to drill a pin low, but it works for me.

Andrew
--------------------
FUFU

Join us @:
www.bowlingballexchange.com
www.bowlingkingdom.com
www.fullsizechevy.com
www.fitday.com
www.soonersports.com
www.dallascowboys.com

Title: Re: Pin under middle finger
Post by: Krumpy300 on February 16, 2006, 07:35:36 AM

I am 5 1/2 over by 3/4 up.
--------------------
Repetition is everything..