win a ball from Bowling.com

Author Topic: Pitch change = Span change?  (Read 17116 times)

Boss_Hog

  • Jr. Member
  • **
  • Posts: 56
Pitch change = Span change?
« on: November 14, 2013, 08:58:00 AM »
If I go 1/8 reverse in my thumb would I need to adjust the overall span?

 

bullred

  • Sr. Member
  • ****
  • Posts: 301
Re: Pitch change = Span change?
« Reply #16 on: November 26, 2013, 03:50:31 PM »
Sounds like you all are disregarding the " Proper" way to hold a ball.  Used to have a lot of success with folks showing them a proper "hold" and release versus a "cookbook" fitting. 

A long overlooked issue of BTM had articles on "fishhooking" the fingers and "setting" the thumb.   Those two articles should have been required reading for bowlers and especially ball "fitters".

But in all fairness, trying to fit a lady with a weak wrist versus a gorilla with crocked wrist

JustRico

  • Hero Member
  • *****
  • Posts: 2652
Re: Pitch change = Span change?
« Reply #17 on: November 26, 2013, 04:51:50 PM »
There is a HUGE difference between reading an article and knowing how to fit as well as the difference between a static fit vs a dynamic fit...the proper way to fit a person is to fit them not a book or a by a fad...fish hooking, using your term, would more than likely delay the fingers causing possible tendon damage from the pulling effect...understand they are angles and no two hands are alike
Co-author of BowlTec's END GAMES ~ A Bowler's COMPLETE Guide to Bowling; Head Games ~ the MENTAL approach to bowling (and sports) & (r)eVolve
...where knowledge creates striking results...
BowlTEc on facebook...www.iBowlTec.com

ccrider

  • Hero Member
  • *****
  • Posts: 2230
Re: Pitch change = Span change?
« Reply #18 on: November 27, 2013, 11:19:05 AM »
Fishhooking is simply a descriptive term explaining more firmness with the fingers while relaxing the thumb.

The starting point 4/0 is consistent with Bill Taylor's chart, as is the 1/8 1/16 adjustments. These charts give you a good starting point but ultimately, every bowler's hand is different. As a result, adjustments have to be made based on the bowler's hand and what the desired result is.

JessN16

  • Hero Member
  • *****
  • Posts: 3716
Re: Pitch change = Span change?
« Reply #19 on: February 13, 2014, 12:43:00 AM »
There's got to be more to this than a simple formula.

The cut-to-cut measurement of my span comes out at 4 3/16. That suggests reverse pitch is needed. But I have always had a problem dropping the ball, squeezing it, etc.  As a result I now have some chronic wrist issues thanks to 20+ years of having an ill fit.

About 2 years ago, I made a big move and went from 1/8 reverse in the thumb to 3/8 forward. I noticed an immediate improvement in the pain (or lack thereof) I had in my wrist and hand. But over the last three months or so, I've found myself having a problem again with dropping the ball and feeling the need to squeeze it to hold onto it.

I'm about to take a couple of balls and go from 3/8 forward to 11/16 forward and see what happens.

What hasn't changed over this time is the overall span. Regardless, according to Taylor's work, I never should have gone to forward pitch to begin with. However, there's no doubt it felt better and took some stress off my hand/wrist in the process.

Jess

Perfect Approach Pro Shop

  • Sr. Member
  • ****
  • Posts: 339
Re: Pitch change = Span change?
« Reply #20 on: February 13, 2014, 09:09:58 AM »
There's got to be more to this than a simple formula.

The cut-to-cut measurement of my span comes out at 4 3/16. That suggests reverse pitch is needed. But I have always had a problem dropping the ball, squeezing it, etc.  As a result I now have some chronic wrist issues thanks to 20+ years of having an ill fit.

About 2 years ago, I made a big move and went from 1/8 reverse in the thumb to 3/8 forward. I noticed an immediate improvement in the pain (or lack thereof) I had in my wrist and hand. But over the last three months or so, I've found myself having a problem again with dropping the ball and feeling the need to squeeze it to hold onto it.

I'm about to take a couple of balls and go from 3/8 forward to 11/16 forward and see what happens.

What hasn't changed over this time is the overall span. Regardless, according to Taylor's work, I never should have gone to forward pitch to begin with. However, there's no doubt it felt better and took some stress off my hand/wrist in the process.

Jess

Changing pitch does not dictate changing span. I am IBPSIA certified and use there system. With IBPSIA, a 4" span is 0 for forward/reverse pitch. This is just a starting "reference" and not the bible. From there you add/subtract due to flexibility, skin moisture, length of thumb. If you have no thumb flexibility, you would not want excessive reverse as it puts your thumb in a nun relaxed position. If you have a short thumb, too much reverse will cause squeezing as your thumb has no issue clearing thumb hole. If you have extremely dry skin, excessive reverse will cause squeezing. Like I said, this is "reference" as everyone's hands are different. I have over 3000 fitting slips in my data base and probably would be hard to find two exactly the same as I fit to the persons hand and style of bowling.
J. Helton
Perfect Approach Pro Shop

JustRico

  • Hero Member
  • *****
  • Posts: 2652
Re: Pitch change = Span change?
« Reply #21 on: February 13, 2014, 10:16:31 AM »
There are references & guidelines and then there is experience...fitting is part science and part art...you have to know how to blend the 2...

Nicely said Jody
Co-author of BowlTec's END GAMES ~ A Bowler's COMPLETE Guide to Bowling; Head Games ~ the MENTAL approach to bowling (and sports) & (r)eVolve
...where knowledge creates striking results...
BowlTEc on facebook...www.iBowlTec.com

JessN16

  • Hero Member
  • *****
  • Posts: 3716
Re: Pitch change = Span change?
« Reply #22 on: February 14, 2014, 03:18:24 AM »
I'll follow up with some other information if it would help ...

The Coke bottle test has me appearing to need something between 0 and 1/4 palm-under. It typically ends up around 1/8.

That's what a former driller of mine attempted to do. I had always had 1/8 away (left lateral) pitch prior to that. But as soon as we went with under pitch, I started having pain in the thumb joint, and had some issues clearing the thumb. We had to switch back to 1/8 away.

In the years since, I've moved to 0, which is where I am now. The older I get (40 now) the more the Coke bottle test is calling for under pitch. It shows closer to 1/4 than it ever has. I'm wondering if I should combine more forward with a move to under pitch.

Jess

LuckyLefty

  • Hero Member
  • *****
  • Posts: 17348
Re: Pitch change = Span change?
« Reply #23 on: March 22, 2014, 06:50:11 AM »
Jess,

A move to lateral under and leaving your forward pitch could have you doing the Machuga Flop unintentionally!

IF I were going to go to under I would go be very careful to add some reverse to your current point.  For each 1/16 under lateral I would add 1/8 reverse from your starting point at your extreme forward pitch.  And please go slow!  Be willing to add bevel as you try this.

Real world.  When this going forward trend first started being talked about I would run into more bowlers trying it and talking about going forward as a goal!  They would mention they had done it and note they now had a black line under the flat of their thumb!  Warning nerve damage.  I would add bevel using the Mo Pinel bevel tips and ring finger test and after a few weeks voila no more tingling or black line.

Sometimes two weeks off was necessary.

Jess.  I have to say it is a long time.  But it seems in picturing your wrist position from a long time ago it for a hook bowler was less cupped or even bent backwards compared to most other hook ball bowlers.  This may be how you can go to such extreme forward in relation to your span.

Just Rico and the Perfect Pitch IPSIA poster are quite correct.  Pitch is angle.  Bill Taylor described the starting point of his pitch chart 4 1/4 was 0 Forward/Reverse and a 64 degree angle.  The new chart from the IPSIA is 4 and 0.  This is even a wider angle than Bill Taylor's old charts.  The adjustments obviously the same.  1/8 more span = 1/16 more reverse.*

I find the Bill Taylor charts to be virtually perfect for me if I use my coke bottle test of 1/4 under palm lateral.  (I use less lateral)  Bill who I was fortunate enough to meet, believed in going forward for bowlers with all the adjustments mentioned by Perfect pitch.  Dry thumbs, flexible thumbs, and short thumbs, need more forward, and the converse.

Regards,

Luckylefty
PS ** the angle can be pictured by picturing  a straight line from the front edge of the fingerholes to the front edge of the thumb and measuring the angle of the front surface of that thumbhole.  Really can't be done on a ball but instead on a picture of paper.  Using a circle of 8.5 inches. 
http://www.bowlingball.com/BowlVersity/bowling-ball-specifications
It takes Courage to have Faith, and Faith to have Courage.

James M. McCurley, New Orleans, Louisiana

TheGom

  • Hero Member
  • *****
  • Posts: 577
Re: Pitch change = Span change?
« Reply #24 on: March 22, 2014, 05:59:46 PM »
Just had a look discussion with a new driller about my fit and showed him what a Gold Medal teacher had for me spec wise.....he had me at zero lat and 1/4 forward for my 4 1/16 span...poor flexablity in both fingers and hand. While everyone else had me Reversed and left.

This new driller wants to go more forward, 3/8 and 3/8's left for a 4 1/4 middle and 4 1/16 ring. I asked him to not go as much forward and we settled on 1/4 forward. He also has my fingers at 5/8's rev for this fitting.

I get that nerve issue on the inside base of my thumb and I am worried that more forward without the proper bevel will only make it worse....thoughts?


LuckyLefty

  • Hero Member
  • *****
  • Posts: 17348
Re: Pitch change = Span change?
« Reply #25 on: March 23, 2014, 08:33:30 AM »
3/8 lateral out from a new driller while a gold medal teacher has you at 0 lateral?  Why?  You must have a stiff hand and a very flexible thumb.

In the range of bowlers lateral out that much has to be a 99.6% as far as how many bowlers are lateral out that much.

I have seen one bowler go that much lateral out from 0 out lateral.  He has had marvelous results being down about 20 pins in average on house shot with a move to 5/16 lateral out from a 1/8 lateral out coke bottle test.

He says he is better on sport shots.  I have never seen it.

Good Lucky.

Regards,

Luckylefty
PS what is your Coke bottle test?
It takes Courage to have Faith, and Faith to have Courage.

James M. McCurley, New Orleans, Louisiana

JustRico

  • Hero Member
  • *****
  • Posts: 2652
Re: Pitch change = Span change?
« Reply #26 on: March 23, 2014, 09:06:31 AM »
Very few, if any on this website understand the difference between a static fit and a dynamic one...I have yet to see a bowler 'throw' a coke bottle down the lane
Co-author of BowlTec's END GAMES ~ A Bowler's COMPLETE Guide to Bowling; Head Games ~ the MENTAL approach to bowling (and sports) & (r)eVolve
...where knowledge creates striking results...
BowlTEc on facebook...www.iBowlTec.com

TheGom

  • Hero Member
  • *****
  • Posts: 577
Re: Pitch change = Span change?
« Reply #27 on: March 23, 2014, 08:49:56 PM »
3/8 lateral out from a new driller while a gold medal teacher has you at 0 lateral?  Why?  You must have a stiff hand and a very flexible thumb.

In the range of bowlers lateral out that much has to be a 99.6% as far as how many bowlers are lateral out that much.

I have seen one bowler go that much lateral out from 0 out lateral.  He has had marvelous results being down about 20 pins in average on house shot with a move to 5/16 lateral out from a 1/8 lateral out coke bottle test.

He says he is better on sport shots.  I have never seen it.

Good Lucky.

Regards,

Luckylefty
PS what is your Coke bottle test?

Double L, I have a stiff, very little flexablity thumb, but my fingers are not as bad.

I did not understand your 99.6% comment

BG

LuckyLefty

  • Hero Member
  • *****
  • Posts: 17348
Re: Pitch change = Span change?
« Reply #28 on: March 23, 2014, 11:00:31 PM »
Rico,

Tell us how you perform your dynamic fit?  Thanks,

99.6%, I have never seen anyone test at 3/8 out lateral ever.  Especially after they have tested at 0 with a gold level teacher.

I have seen 3/16 lateral out, once that was a proper fit and great roll for the guy.

REgards,

Luckylefty
It takes Courage to have Faith, and Faith to have Courage.

James M. McCurley, New Orleans, Louisiana

JohnP

  • Hero Member
  • *****
  • Posts: 5819
Re: Pitch change = Span change?
« Reply #29 on: March 24, 2014, 03:38:33 PM »
I don't remember ever using over 5/16 right lateral (right hander).  That guy could lay his thumb over perpendicular to his wrist and touch the pad of his palm.  --  JohnP

TheGom

  • Hero Member
  • *****
  • Posts: 577
Re: Pitch change = Span change?
« Reply #30 on: March 24, 2014, 04:20:34 PM »
Maybe I miss explained....3/8 forward and 3/8 to the left when looking down at the holes...hope this helps because I think it came across 3/8's right or the thumb more under the palm, this is why LL asked me about a very flexable thumb.