BallReviews

General Category => Drilling & Layouts => Topic started by: skwira001 on November 01, 2014, 05:55:46 PM

Title: Pitches on the mill table
Post by: skwira001 on November 01, 2014, 05:55:46 PM

http://www.ballreviews.com/drilling-layouts/drill-press-specs-for-home-proshop-t287557.0.html;msg2334684#msg2334684

I'm referring back to this topic.  I have the exact same setup as this: http://s793.photobucket.com/user/EFFEN10/media/034.jpg.html

My question is, how do I know how much to crank the table in order to dial in the pitches?  Like how much does one full turn on the Y axis change the pitch from 0,0?

Title: Re: Pitches on the mill table
Post by: Rightycomplex on November 02, 2014, 04:48:24 AM

Take your plug cutter and zero out the table. There also should be   a ready out on the table itself. Other than that you'll just have to get some junk balls and experiment.