win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Plug storage  (Read 1723 times)

Greg T

  • Hero Member
  • *****
  • Posts: 19916
  • Collateral Damage
Plug storage
« on: September 26, 2008, 02:04:12 AM »

 Anyone know the best way to store Wizard plug? Cold, like 60* to 65* or warmer like 72* or so?




--------------------
If yer arm don''t hurt ya ain''t shiftin it right!
 

RESEARCH!   Don''t be a maroon!!.


 
Logged
AllBowling.com Off-Ramp!           

 

mw11x300

  • Full Member
  • ***
  • Posts: 223
Re: Plug storage
« Reply #1 on: September 26, 2008, 10:15:23 AM »
In my experience it is best to split up the gallon jug into smaller airtight containers and store the extra in a cooler environment.  I usually part the gallons into quart sized pickling jars and store it in a cool place.  Nothing wrong with keeping it in the gallon jug if you use it often, but if it is left unused for a while it will crystalize and be useless.
Logged

qstick777

  • Hero Member
  • *****
  • Posts: 5188
Re: Plug storage
« Reply #2 on: September 26, 2008, 11:38:29 AM »
I've never had any problems with any of the plug that I've used - Ebonite and another quick set that I use (not "offical" bowling ball plug, but very similar to Wizard).  I keep them in my garage, which is not climate-controlled.  Summer temps get into the high 80s and winter into the 30s or 40s (usually about 10-20 degrees warmer than outside).

I keep them stored in a base cabinet - off the floor.  I think as long as you keep them sealed, the air is probably more of a factor than storage temp.

--------------------
Unoffical Ballreviews.com FAQ

Search Ballreviews entire database here
Logged

ccrider

  • Hero Member
  • *****
  • Posts: 2230
Re: Plug storage
« Reply #3 on: September 26, 2008, 12:33:31 PM »
Do you leave the pumps in or take them out after each use?
--------------------
Those that can do. Those that can't complain. Pimpin ain't easy, but it's mandatory.

Most things we like, we don't need. Most things we need, we don't like. Don't confuse your likes with your needs.
Logged

Greg T

  • Hero Member
  • *****
  • Posts: 19916
  • Collateral Damage
Re: Plug storage
« Reply #4 on: September 26, 2008, 01:01:15 PM »

 I was planning on leaving the pumps in and storing in my basement where I do my work. It stays about 65* down there.




--------------------
If yer arm don't hurt ya ain't shiftin it right!
 

RESEARCH!   Don't be a maroon!!.


 
Logged
AllBowling.com Off-Ramp!           

bowler001

  • Full Member
  • ***
  • Posts: 228
Re: Plug storage
« Reply #5 on: September 30, 2008, 07:23:20 PM »
I store my wizard plug in my garage since all my pro shop equipment is in there, and living in Alaska, the temperature is all over the friggin place, and the only problem, and it's not really a problem, is the hardener crystalizes at the very tip of the pump. I take a little screwdriver and break it out, usually in one solid piece and everything flows fine after that. And I don't use my plug very often. I really wouldn't be too concerned about it.
Logged
Pages: [1]
« previous next »