Author Topic: psycho layout (Read 941 times)

B-Mac · « **on:** February 19, 2009, 09:08:46 AM »

4 1/2 PAP
Med-high track
14-15 MPH
High rev not sure on the amount

Ball Raw Hammer Psycho
2-3 pin (2.5 to be exact)
2.75 top

Looking for length but not too snappy. More length with hard arcing back end. I was thinking pin under ring CG out at 45 degrees

Any suggestions?

--------------------
Robert McPheron

Strikes are nice but spare win.

Burak Natal · « **Reply #1 on:** February 20, 2009, 05:05:00 AM »

Pin under ring would be around 3-1/2 to 4 inches from your PAP which is way too strong if you want length.

I would place the pin 5 inches from PAP below fingers (which roughly puts the pin under the middle finger for you). To fine tune the reaction later, place the CG to leave enough side/finger weight for an x-hole (+3/4 ounces positive would be enough).

Adjust the surface for length. If you want to tame the backend, place the x-hole 2-1/4 inches away from PAP towards the pin, on the line from pin through your PAP.

Hope this helps..
--------------------
Regards,
Natal

Author Topic: psycho layout (Read 941 times)

B-Mac

psycho layout

Burak Natal

Re: psycho layout