Author Topic: Help with my Flame!! (Read 1463 times)

tenpin · « **on:** July 15, 2003, 06:12:06 AM »

I drilled up a flame reactive orange. I need some help with what I believe is going to be a weight hole on where I should place it. I am fairly new to drilling my own equipment so any help would be appreciated. I drilled it up like this diagram below.

o o

cg

o
I threw the ball and I am tracking over the top edge of the thumb hole. I usually track just to the left about a 1/4 in from the bottom. So I took it home and scaled it again. I have a 1/4 thumb weight, and 5/8 top weight. Most of my equipment I use has about a 1/4 finger weight with about 1 - 2oz of top weight. I do have one ball, which is the diesel particle that has 1/4 thumb weight and 2 5/8 top weight. So I am figuring that I need more top weight to bring the track down. Please let me know if I am right and where I should put the weight hole to gain some top weight. I also do not have a thumb slug in it right now and I am planning on putting one in as soon as they arrive. I thought that I would mention that in case that will help the tracking in any way which I don't believe it will. Thanks for you help, Derek

Edited on 7/15/2003 9:17 PM

charlest · « **Reply #1 on:** July 15, 2003, 10:46:01 PM »

This is a 3 piece (pancake core) ball. With these, thumb weight and negative side weights generally have a much greater effect on a ball's reaction. One effect is that negative side weight and thumb weight can bring a track up slightly higher than it normally is. Side weight and finger weight lower it slightly. If you normally track high as you inidcate, I believe the thumb weight could be raising the track just enough to track over it.

2 piece core (dynamic core) balls like the Diesel will not be affected as much by thumb/side/finger and top weight. It is affected more by pin/CG/MB placement.

I hope some knowledgable driller, like king of the mill or others, can corroborate this.

I suspect that if you drill your thumb hole deeper to remove the thumb weight
or at least some of it, that may lower the track enough.

--------------------
"Those who do not remember history are doomed to repeat it."

Urethane Game · « **Reply #2 on:** July 15, 2003, 11:25:49 PM »

I had the same problem with my orange flame, high track, same drilling. I had another driller take a stab at lowering the track but it seemed that the more the ball tracked up the sooner it thumped.

I still have a pic of the ball with weight hole if interested.

PopPop200 · « **Reply #3 on:** July 15, 2003, 11:40:42 PM »

This is a common problem with this ball. Storm has included instructions with this ball ( At least they did with mine) that mention the problem of ttracking over the thumb, and they tell you to avoid certain drillings.

Author Topic: Help with my Flame!! (Read 1463 times)

tenpin

Help with my Flame!!

charlest

Re: Help with my Flame!!

Urethane Game

Re: Help with my Flame!!

PopPop200

Re: Help with my Flame!!