BallReviews
General Category => Drilling & Layouts => Topic started by: stormerjip on July 23, 2008, 04:01:31 PM
-
basically I have a pretty simple question. hoiw much do you allow from the edge of the hole for outer sleeve to center of slug fir the span
--------------------
show no mercy, kill the wounded, eat the dead
-
I don't understand what you are asking but you have to use a 1 1/2" drill bit for the turbo brand . The Vise allows for a bit 1/16 larger than what size thumb insert you use. You can use 1 1/8 -1 1/4 - or 1 3/8 thumb slug with the "IT" from VISE!!!
-
what im asking is if ur span is 4 1/2 to actual thumb hole what span do us drill the 1 1/2 inch hole to get it to middle of the other
--------------------
show no mercy, kill the wounded, eat the dead
-
With the Griploc system, I measure back from the cut of the middle finger to the cut of sleeve and drill it from there. Once you do it on one ball, all you have to do is use this measurement and hit your lines and your good. I do even put the insert in the sleeve and measure for the fingers anymore. Hope that helps.
-
Are you drilling the ball? Map out the span as usual, line up the thumb with your regular size bit and pitches, then take it out and put the outer sleeve bit in the chuck and drill the hole.
OR
The outer sleeve is 1/16" thick, and the inner sleeve is 1/16" thick = 1/8 total. The slug is 1 1/4". Half of 1 1/4" is 5/8" plus 1/8"= 3/4" from the center of the slug to the outer.
Clear as mud!!??
--------------------
Corey Clayton
Brunswick Amateur Staff
Turbo Grips Staff
Team Canada 2007, 2008, & 2009