win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Question regarding thoe who make their own slugs / molds  (Read 1546 times)

ShoreLefty

  • Full Member
  • ***
  • Posts: 181
Question regarding thoe who make their own slugs / molds
« on: March 16, 2012, 01:35:44 PM »
What are good release agents to use when using the ultimate thumb slug kit?  I see where they (Ultimate) suggest the use of a release agent, but don't seem to sell one.  I know that Pro-Edge sells a release agent, are their any others out there?  Are there any "home" products that will work as a release agent?

 

Thanks


Logged

 

Keith Frye

  • Hero Member
  • *****
  • Posts: 571
Re: Question regarding thoe who make their own slugs / molds
« Reply #1 on: March 16, 2012, 06:02:16 PM »
I don't know of any home made release agents but you can check art supply places.  The spray on this page


 

should work.  You can get by without a release agent.  After hardening, give a few firm (or slightly harder) taps on all sides with a rubber malet. You should then be able to push the slug/mold out with a smaller slug or dowel or screw driver handle.
Logged

Gunny

  • Hero Member
  • *****
  • Posts: 1543
  • Zombie Hunter
Re: Question regarding thoe who make their own slugs / molds
« Reply #2 on: March 16, 2012, 06:07:38 PM »
i don't use any release agent for the slug whether using wizard or other.  as far as the silicone for the mold, didn't use any either.

------------------------------------------------
A bizarre incident occurred in the outskirts of an American suburb.....It was later revealed that the terrible disaster had been caused by the T-Virus.....a mutagentic toxin created by international enterprise Umbrella Incorporated for use in bio-weapon experiments.
 
Don't worry the zombies are looking for brains, you're safe.....
Logged
Pages: [1]
« previous next »