What are good release agents to use when using the ultimate thumb slug kit? I see where they (Ultimate) suggest the use of a release agent, but don't seem to sell one. I know that Pro-Edge sells a release agent, are their any others out there? Are there any "home" products that will work as a release agent?
Thanks
I don't know of any home made release agents but you can check art supply places. The spray on this page
should work. You can get by without a release agent. After hardening, give a few firm (or slightly harder) taps on all sides with a rubber malet. You should then be able to push the slug/mold out with a smaller slug or dowel or screw driver handle.
i don't use any release agent for the slug whether using wizard or other. as far as the silicone for the mold, didn't use any either.
------------------------------------------------
A bizarre incident occurred in the outskirts of an American suburb.....It was later revealed that the terrible disaster had been caused by the T-Virus.....a mutagentic toxin created by international enterprise Umbrella Incorporated for use in bio-weapon experiments.
Don't worry the zombies are looking for brains, you're safe.....