win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Driller question: Oval thumb placement angle?  (Read 1616 times)

DukeHarding

  • Hero Member
  • *****
  • Posts: 5855
Driller question: Oval thumb placement angle?
« on: September 02, 2004, 11:13:39 AM »
I use an oval thumb sleeve, and having been playing around with the angle it's placed in the thumb hole. I've turned the sleeve, so the top (inside of the thumb) is turned closer the the middle finger. (Which tore the skin at the inside top joint.)
Is there a formula for setting the position of the oval? Or is it just by feel?

Thanks . . .

--------------------
You're only as good as your last shot. -- Duke Harding
Logged

 

Re-Evolution

  • Hero Member
  • *****
  • Posts: 2080
Re: Driller question: Oval thumb placement angle?
« Reply #1 on: September 02, 2004, 11:38:33 PM »
I don't know of a formula for figuring it.
When I switched to an oval my driller set-up the measuring ball with my specs and then made a mark where the center of the back of my thumb was and then measured the angle with a quarter scale and it worked out perfectly.
--------------------
STORMIN1

Logged

DukeHarding

  • Hero Member
  • *****
  • Posts: 5855
Re: Driller question: Oval thumb placement angle?
« Reply #2 on: September 03, 2004, 02:28:25 AM »
quote:
I don't know of a formula for figuring it.
When I switched to an oval my driller set-up the measuring ball with my specs and then made a mark where the center of the back of my thumb was and then measured the angle with a quarter scale and it worked out perfectly.
--------------------
STORMIN1



Sromin1,
Thanks for the reply.
I pulled the sleeves out, and repositioned them back to where I had them, previously.
I have a lot of joint wear in my thumb hinge.
Doing a little experimenting, and thought there may be some time of measurement.
I basically have been setting it to a comfortable angle.
--------------------
You're only as good as your last shot. -- Duke Harding
Logged

DukeHarding

  • Hero Member
  • *****
  • Posts: 5855
Re: Driller question: Oval thumb placement angle?
« Reply #3 on: September 03, 2004, 02:29:48 AM »
sorry, should have been STORMIN1.
--------------------
You're only as good as your last shot. -- Duke Harding
Logged

JohnP

  • Hero Member
  • *****
  • Posts: 5819
Re: Driller question: Oval thumb placement angle?
« Reply #4 on: September 03, 2004, 12:06:15 PM »
DukeHarding -- The newest Bill Taylor fitting device measures the thumb angle for use in setting oval thumbs.  I've never used one of these, but have seen them demonstrated.  --  JohnP
Logged

channel surfer

  • Hero Member
  • *****
  • Posts: 2036
Re: Driller question: Oval thumb placement angle?
« Reply #5 on: September 03, 2004, 05:36:39 PM »
The best thing you can do is expierment with differnet positions. Which ever one feels better, and works the best is the one you should use.
--------------------
www.csbowling.vze.com

www.bowlersdream.com - save an additional $3 off any $100 order by simply typing in CSB into the coupon code area at checkout.
Logged
Pages: [1]
« previous next »