BallReviews

General Category => Drilling & Layouts => Topic started by: Fatboy8 on February 09, 2007, 08:34:21 AM

Title: Rico drilling with a mass bias??
Post by: Fatboy8 on February 09, 2007, 08:34:21 AM

Just wondering the specifics on how to Rico drill a ball with a marked mass bias. Thanks!
--------------------
Lane #1-Ebonite-Brunswick

Title: Re: Rico drilling with a mass bias??
Post by: JohnP on February 10, 2007, 02:45:38 PM

BrunsRich -- Two questions, when you say lay it out at 45 degrees, are you talking 45 degrees PAP-pin-MB or 45 degrees midline to MB?  If the layout is being used on a ball that has been plugged, do you use the original cg or the cg after plugging?  Not a whole lot of difference in either case, but might be enough to affect reaction???  --  JohnP