BallReviews

General Category => Drilling & Layouts => Topic started by: I Flush 8s on January 05, 2009, 02:42:41 PM

Title: rico on a dimension?
Post by: I Flush 8s on January 05, 2009, 02:42:41 PM
has anyone thrown this drilling on this ball
just picked up a new one and i wanted to kno if it rolled well with this layout

i want this ball to roll up a tad earlier and roll off the break i really dont want to hard of a breakpoint snap

specs
pap= 5 inches over 0 up or down
speed= 16 - 17 mph
rpms= med-high tweener

any input would be nice thanks in advance
Title: Re: rico on a dimension?
Post by: Spider Ball Bowler on January 05, 2009, 10:46:21 PM
go with the pin below the ring...
--------------------
Ahhh Disco Biscuits!
Title: Re: rico on a dimension?
Post by: I Flush 8s on January 05, 2009, 10:50:47 PM
ok well its a rather long pin 3.5 pin dont want the ball to have the cg too close to the thumb and start flaring over the thumb like my killer instinct pearl did thats my concern basically
Title: Re: rico on a dimension?
Post by: I Flush 8s on January 06, 2009, 09:59:36 AM
anyone??
Title: Re: rico on a dimension?
Post by: jbuzz31 on January 06, 2009, 10:02:58 AM
quote:
ok well its a rather long pin 3.5 pin dont want the ball to have the cg too close to the thumb and start flaring over the thumb like my killer instinct pearl did thats my concern basically


you should be able to adjust the weight hole distance to account for that.  or move the pin a  1/3 or 1/2 an inch higher on the grip center.
--------------------
Ive Eaten From The Insane Root That Imprisons Reason