BallReviews

General Category => Drilling & Layouts => Topic started by: SpareK on April 03, 2009, 12:37:58 PM

Title: Rico question
Post by: SpareK on April 03, 2009, 12:37:58 PM

The cg is 2's inch right of Mb. Should  I line up the cg at 45 or the mb? Or split the difference and drill the Balance hole between the two. Thanks in advance.
A>A

Title: Re: Rico question
Post by: charlest on April 03, 2009, 09:00:48 PM

PAP-pin-MB angle should be 45 degrees.
--------------------
"None are so blind as those who will not see."

Title: Re: Rico question
Post by: JustRico on April 06, 2009, 11:44:35 AM

Pin and mass bias should be aligned at 45 degrees. You should try and find one with the CG more in align, as one that far out of alignment will make it difficult if a hole is necessary. If a hole is necessary, it should be placed in the mass bias for optimum reaction.
--------------------
Formerly BrunsRico

Title: Re: Rico question
Post by: JustRico on April 08, 2009, 10:40:28 PM

ya that should work. What is the top weight?
--------------------
Formerly BrunsRico