BallReviews

General Category => Drilling & Layouts => Topic started by: laneman on April 05, 2007, 11:51:01 AM

Title: Rico Surface
Post by: laneman on April 05, 2007, 11:51:01 AM

Was wondering if you guys get the same reaction with the Rico..

It seems the best surface prep to use this drilling is either polished or 4000,lower than 4000 the ball seems to roll too early and hit weak.

I really like this layout(have it in a OI),very nice readable ball reaction.



Edited on 4/5/2007 7:56 PM

Title: Re: Rico Surface
Post by: Joe Jr on April 05, 2007, 07:55:30 PM

A drilling that creates as much midlane as this one demands oil in the heads and mids.
--------------------
Back were I belong...with Roto Grip.
My Vid (http://"http://youtube.com/user/BLefty")
Banned under the user name Richard Cranium
Formerly Brunswick Lefty

Edited on 4/5/2007 7:54 PM

Title: Re: Rico Surface
Post by: laneman on April 05, 2007, 08:00:38 PM

I have 70-75 units in the heads and 40-45 in the midlane.

Im a tweener.. PAP 5" over 1" up

Title: Re: Rico Surface
Post by: zeusjr on April 05, 2007, 10:01:30 PM

I've take the cover all the way to 1000 with out any issue, but once I went past that the ball started flaring over the fingers...

Title: Re: Rico Surface
Post by: metallicaaaaaaa on April 05, 2007, 10:03:22 PM

The OI I had drilled Rico flared over my fingers and it was polished...I really didn't like that drill at all. Just me though probably
--------------------
"I don't wanna go home! I wanna go to Reno!"

Title: Re: Rico Surface
Post by: Sawuser on April 06, 2007, 03:43:35 AM

I have a black raspberry drilled Rico sanded to 1000grit. So far NO issues with rollout or weak hit. So far it has tremendous hitting power & carry. I used it on second league shot if that tells you anything. I would imagine hand position, release, & ball speed would have a lot to do with that.
--------------------
Righty
Think about it!

The trouble with our liberal friends is not that they are ignorant, but that they know so much that isn't so. Ronald Reagan

Edited on 4/6/2007 3:44 AM

Title: Re: Rico Surface
Post by: Bowler19 on April 06, 2007, 02:31:51 PM

I have a rico drill with a raised Balance hole on my saturn use it at 800-1000 grit and get a great reaction
--------------------
Bowler19
But be not afraid of greatness: some are born great, some achieve greatness, and some have greatness thrust upon them.-W. Shakespear
"Some are born great, some achieve greatness, other get it as a graduation present"
Robin Williams

Title: Re: Rico Surface
Post by: laneman on April 06, 2007, 08:01:51 PM

I took it to 2000,had a 299 with it tonight(solid 9 pin)

The center I was at plays tighter than where I work,ball worked great there.

Edited on 4/6/2007 8:04 PM