BallReviews

General Category => Drilling & Layouts => Topic started by: Ol Stranker on August 04, 2006, 09:36:43 AM

Title: Six Inch Pin
Post by: Ol Stranker on August 04, 2006, 09:36:43 AM

I wonder if any of you drilling experts would help me with the Heat Blast 2nd that I bought off ebay--six inch pin to cg, low top, about 1 and 1/2 oz. Is there anything I can do with it? (bowling wise, not doorstop or boat anchor) for info pap 4 1/2 over, 7/8 up.  Thanks a lot.

Title: Re: Six Inch Pin
Post by: Ol Stranker on August 04, 2006, 07:40:57 PM

Thanks, Dan--I hope it works out ok.

Title: Re: Six Inch Pin
Post by: MegaMav on August 04, 2006, 09:12:01 PM

try semi-pin axis drilling.

it would be a perfect spec set up for it.

Title: Re: Six Inch Pin
Post by: Ol Stranker on August 04, 2006, 09:21:46 PM

Thanks, MegaMav--I think I will try something like that.

Title: Re: Six Inch Pin
Post by: JohnP on August 04, 2006, 09:25:10 PM

Before you do anything with it, confirm the cg location and top weight.  They could be mismarked.  --  JohnP

Title: Re: Six Inch Pin
Post by: Ol Stranker on August 04, 2006, 10:26:29 PM

Good Idea, JohnP--I will do that--Thanks