Author Topic: layout on a used Stinger 2pc Low Flare (Read 1002 times)

michelle · « **on:** February 26, 2004, 08:38:52 PM »

Question about what to expect since I have not thrown anything with the layout that was on a ball I snagged as part of a 2-ball package deal...

The ball began life with an unknown top weight and about a 2 1/2 inch pin

The pin is in the grip center with the cg being down but towards the PAP and in line with a weighthole in the thumb-positive quadrant. For me, this will work out to roughly a 5x2 layout.

I've just never punched anything up except a spare ball that had the pin in grip center, so I was just curious what to expect...

Loki300 · « **Reply #1 on:** February 27, 2004, 07:39:56 PM »

I have a V2 Dry and was wondering if the Stinger 2P LF would be a good ball between that and my Reactoin Rip. I know the stinger is supposed to be just stronger than the V2, but i've heard it is a lot stronger than advertised. My V2 is driled label lev, and my Rip is pin above bridge c.g stacked.

Would get the V2 Clean buti think that would be too close to the Rip.

Author Topic: layout on a used Stinger 2pc Low Flare (Read 1002 times)

michelle

layout on a used Stinger 2pc Low Flare

Loki300

Re: layout on a used Stinger 2pc Low Flare