win a ball from Bowling.com
« previous next »
Pages: [1]

Author Topic: Drilling out the MB mark  (Read 1036 times)

cooksey

  • Hero Member
  • *****
  • Posts: 918
Drilling out the MB mark
« on: March 11, 2006, 05:11:33 PM »
Hello all, I don't think it matters but wanted to check with some of our experts here to be sure. Does it have any effect on a ball if you drill the thumb hole on top of the mb mark? Any help is appreciated.

cooksey
--------------------
" Focus the next shot is critical"

AIM:johncooksey24
Logged
" Focus the next shot is critical"

AIM:johncooksey24

 

YeahHossNV

  • Hero Member
  • *****
  • Posts: 626
Re: Drilling out the MB mark
« Reply #1 on: March 12, 2006, 01:54:46 AM »
makes it a lot less dynamic
Logged

cooksey

  • Hero Member
  • *****
  • Posts: 918
Re: Drilling out the MB mark
« Reply #2 on: March 12, 2006, 02:01:14 AM »
Thanks everyone, I purchased a used track exception and was going to use the current layout and just move the thumb bit with the current layout I will end up drilling out the mb from the look of the pic of the ball I have anyway that s why I am asking. If you would like to see the pic just let me know.

cooksey
--------------------
" Focus the next shot is critical"

AIM:johncooksey24
Logged
" Focus the next shot is critical"

AIM:johncooksey24

YeahHossNV

  • Hero Member
  • *****
  • Posts: 626
Re: Drilling out the MB mark
« Reply #3 on: March 12, 2006, 02:29:40 AM »
let us see the pic and tell us what you are looking for it to do. I must warn you though without using a determinator it will be impossible to tell the true location of the mass bias since it moved when it was drilled and now the dynamics are different.
Logged
Pages: [1]
« previous next »