BallReviews

General Category => Drilling & Layouts => Topic started by: jjweb on March 16, 2005, 02:18:30 PM

Title: Span & Pitch
Post by: jjweb on March 16, 2005, 02:18:30 PM

I was thinking of adding some forward pitch in my fingers. Currently I'm at zero-zero in the fingers with 1/4 right and an 1/8 reverse, thumb.

I saw it suggested in the MoRich "Future of ball motion" presentation. It said it can increase revs (1/8 forward in both fingers). I'm looking to get that extra UMPH at release.

I am also thinking about dropping my ring finger an 1/8, as I have been having problems with swelling in it. (Span and pitches in profile)

I think my ring is too stretched out...

Any comments, opinions, suggestions or objections?
--------------------
The bowling gods said "let there be strikes" and then there was Dyno-Thane!

Title: Re: Span & Pitch
Post by: jjweb on March 16, 2005, 11:37:06 PM

I also thought about doing this: 3/8 forward middle - 3/8 reverse ring. The MoRich information states that this will increase axis rotation and tilt.


Would dropping my ring an 1/8 be too big of a change? I know something needs to be done, that's for sure.

Thanks!
--------------------
The bowling gods said "let there be strikes" and then there was Dyno-Thane!

Title: Re: Span & Pitch
Post by: jjweb on March 18, 2005, 06:40:17 AM

If I even my fingers cut-to-cut, how would I compensate for an 1/8 forward in the fingers? Is it even worth trying with zero - zero in the fingers? I am using power lifts which add a 1/4 forward, but I feel I still don't get enough lift at the bottom.

Wouldn't that stretch the span again?

Would I need to add more reverse in the thumb to compensate for the fingers staying in the ball longer?
--------------------
The bowling gods said "let there be strikes" and then there was Dyno-Thane!

Title: Re: Span & Pitch
Post by: jjweb on March 18, 2005, 07:24:26 AM

TTT
--------------------
The bowling gods said "let there be strikes" and then there was Dyno-Thane!

Title: Re: Span & Pitch
Post by: Goof1073 on March 18, 2005, 07:30:07 AM

You need to find a good driller and have him look at your hand / current specs prior to making changes.  If your current set-up isn't correct than making changes off of an incorrect starting point isn't going to help things.  You also need to keep in mind that changes in Fwrd/Rev finger pitches will effect how your span feels.
--------------------
-Chris: DJ's Pro Shop : Auburn, MA

Title: Re: Span & Pitch
Post by: jjweb on March 18, 2005, 07:37:18 AM

My thumb pitch and middle finger span are perfect, it's my ring finger that's giving me problems. I'm always looking for ways to increase my wimpy rev rate...

I thought it would be worthwhile to try some forward in the fingers.
--------------------
The bowling gods said "let there be strikes" and then there was Dyno-Thane!