BallReviews

General Category => Drilling & Layouts => Topic started by: thedjs on March 01, 2016, 09:58:51 AM

Title: Span question
Post by: thedjs on March 01, 2016, 09:58:51 AM

Most of my equipment was drilled when I was using a Robby's wrist support and the Ebonite support with the extended finger.  I stopped using these supports a couple of months ago and now it feels like I can't get the ball out on the lane.  More tape in the thumb hole helps a little but also causes me to sometimes hang in the ball.

I was wondering if having a slightly short span would cause this problem? 

 

Title: Re: Span question
Post by: SVstar34 on March 01, 2016, 10:50:16 AM

Yes it can be causing that. If you were measured with the wrist supports and now no longer using them it will be different

Title: Re: Span question
Post by: JustRico on March 01, 2016, 04:16:49 PM

Your wrist is now in a different position more than likely, causing a different release angle plus the restriction the wrist supported created changing your grip...get it reevaluated

Title: Re: Span question
Post by: thedjs on March 01, 2016, 05:42:38 PM

Thanks guys.  I think I'd better check with my ball driller and get re-measured.

Thanks again.